Pyramid DC Receiver Manuale di Installazione Scaricare il pdf (Pagina 4)

Page 4

Pyramid Universal Dome Interface Installation Manual

PRODUCT SAFETY

WARNING

 Please follow these instructions as you install the equipment and keep them for future use.

 Installation is only to be carried out by competent, qualified and experienced personnel in accordance with the

country of installations National Wiring Regulations. Failure to do so can result in injury or death by electric

shock.

 The module can operate from any +12V DC or 24V AC class 2 isolated power supply capable of providing

100mA.

 The module is susceptible to damage from Electrostatic Discharge (ESD). Take normal ESD precautions when

handling your network card. ESD prevention kits are available from most electronics distributors.

 Do not exceed the voltage and temperature limits given in the specification.

 If you have any problems, contact Baxall Limited.

 There are no user serviceable parts in this equipment.

ELECTROMAGNETIC COMPATIBILITY (EMC)

CAUTION

 This is a Class A product. In a domestic environment this product may cause radio interference in which case

the user may be required to take adequate measures.

 This product is intended for use in general purpose CCTV applications in a residential, commercial or light

industrial EMC environment. Refer to Baxall Limited before using the product in medical and/or intrinsically

safe applications or in an industrial EMC environment.

 The product must be installed in accordance with good installation practice for EMC to enable the product to

function as intended and to prevent EMC problems.

 Contact Baxall Technical Support to obtain a specification defining the acceptable levels of product degradation

with regard to EMC immunity.

MANUFACTURERS DECLARATION OF CONFORMANCE

A Declaration of Conformity in accordance with the above EU standards has been made and is on file at Baxall

Limited, Stockport, SK6 2SU, England.

The manufacturer declares, that the product supplied with this document is complaint with the provisions of the EMC

Directive 89/336 EEC, the Low Voltage Directive LVD 73/23 EEC the CE Marking Directive 93/68 EEC and all associated

amendments.

UNPACKING

Keep your packaging for use if your Universal Dome Interface is stored for an extended period or needs to be returned

for any reason. The packaging should contain:-

 A Universal Dome Interface (PY-UDI-L, PY-UDI-H or PY-UDI-HR)

 An A4 Module Description Sheet (for installation details)

 These instructions

 Two identical barcodes

Check the product code on the serial number label. If you have an incorrect item or it is damaged then inform the

suppliers and carriers immediately. If this is the case, do not attempt to use the equipment.

BARCODING

The Universal Dome Interface is supplied with two identical barcodes. Remove one and affix it to the module description

sheet, remove the other and affix it to the module.

The barcode gives the unique 48-bit neuron ID to the module. This neuron ID is also stored inside the module and will

be transmitted onto the network whenever the service pin on the front panel of the module is pressed. Before

installation, make a careful note on your module description sheet of all your installation details and the proposed

location of the module. Then during subsequent installation using the Windows 95/98 installation tool the neuron

ID can be entered.

We recommend that during a system installation you store all module description sheets in a ring-bound file, and

keep them for reference after the installation is complete.

1 2 3 4 5 6 7 8 9 ... 23 24

Commenti su questo manuale

Nessun commento

Pyramid DC Receiver Manuale di Installazione Pagina 4

Commenti su questo manuale

Prodotti e manuali riguardandi Ricevitore Pyramid DC Receiver